Table of Contents
Advertisement
4A-14 FRONT DRIVE SHAFT
• When installing right oil seal (1), use care so that oil seal in
proper direction as shown figure.
• Be sure apply grease to oil seal lip and bearing side space
indicated in figure.
"A" : Grease 99000-25010
INSTALLATION
CAUTION:
• To avoid excessive expansion of boot and consequen-
tial disconnection of joint in boot, do not pull differen-
tial side joint housing.
• Protect oil seals and boots from any damage, prevent-
ing them from unnecessary contact while installing
drive shaft.
• Do not hit joint boot with hammer. Inserting joint only
by hands is allowed.
• Make sure that differential side joint is inserted fully
and its snap ring is seated as it was.
Install drive shaft assembly by reversing removal procedure and
noting following points.
• Clean front wheel bearing oil seal (1) and then apply grease.
Replace it if required.
"A" : Grease 99000-25010
Advertisement
Table of Contents
