For Center Shaft And Center Bearing Support - Suzuki Ignis Service Manual

4) Draw away cage (1) by using bearing puller (2), and remove
boot (3) from shaft.
5) Remove boot band, then pull out differential side boot from
shaft.
6) Pull out damper through shaft. (if equipped)
7) Undo boot bands of wheel side joint boot, then pull out boot
through shaft.
CAUTION:
Do not disassemble wheel side joint. If any malcondition
is found in any joint, replace it as assembly.

For Center Shaft and Center Bearing Support

1) Remove right side oil seal from center bearing support (1).
2) Remove circlip by using special tool.
Special tool
(A) : 09900-06108
3) Using hydraulic press (1), draw out center shaft (2) from cen-
ter bearing.
4) Remove left side oil seal from center bearing support (3).
FRONT DRIVE SHAFT 4A-7