Front Brake Hose/Pipe - Suzuki Ignis Service Manual

BRAKE HOSE/PIPE

FRONT BRAKE HOSE/PIPE

REMOVAL
1) Raise and support vehicle properly. Remove tire and wheel.
NOTE:
This operation is not necessary when removing pipes connecting master cylinder.
2) Clean dirt and foreign material from both flexible hose end and pipe end fittings.
3) Remove brake flexible hose or pipe.
INSTALLATION
Reverse brake flexible hose installation procedure, noting the followings.
• Make sure that steering wheel is in straight-forward position and flexible hose has not twist or kink.
• Check to make sure that flexible hose doesn't contact any part of suspension, both in extreme right and
extreme left turn conditions. If it does at any point, remove and correct. Fill and maintain brake fluid level in
reservoir.
• Bleed brake system. Refer to "AIR BLEEDING OF BRAKE SYSTEM".
• Perform brake test and check installed part for fluid leakage.
BRAKES 5-41