Table of Contents
Advertisement
4) Loosen propeller shaft bolt connecting propeller shaft No.1
with propeller shaft No.2, but keeping their connection provi-
sionally.
CAUTION:
Don't damage joint seal (1) to prevent lubrication defect
of joint.
5) Loosen center support bolt, then remove propeller shaft
No.1 with No.2.
1. Center support
1
6) Disconnect propeller shaft No.1 from propeller shaft No.2.
INSPECTION
• Check propeller shaft connecting bolts for looseness. If
looseness is found, tighten to specified torque.
• Check propeller shaft joints for wear, rattle and damage. If
any defect is found, replace.
• Check propeller shaft center support for biting of foreign mat-
ter, crack, abnormal noise and damage. If any defect is
found, replace.
• Inspect propeller shaft and flange yoke for damage, and pro-
peller shaft for runout.
If damage is found or shaft runout exceeds its limit, replace.
Propeller shaft runout
Limit : 0.7 mm (0.028 in.)
PROPELLER SHAFTS 4B-3
Advertisement
Table of Contents
