Brake Back Plate (For 4Wd Vehicle); Master Cylinder Reservoir - Suzuki Ignis Service Manual

BRAKE BACK PLATE (FOR 4WD VEHICLE)

REMOVAL AND INSTALLATION
Refer to "REAR AXLE SHAFT AND WHEEL BEARING (4WD VEHICLE)" in Section 3E.
MASTER CYLINDER
1. Reservoir tank
2. Retainer
3. Grommet
: Apply brake fluid.
4. Master cylinder body
5. Secondary return spring
6. Secondary cup
: Confirm installing direction Size of cup : 6=11>14>8 .
7. Secondary piston
: Apply brake fluid to contact surface of cup.
8. Sleeve cup
: Confirm installing direction.
1
9. Sleeve
10. Primary piston
11. Primary cup
12. Washer
13. Cap
14. Cap cup
15. Master cylinder gasket

MASTER CYLINDER RESERVOIR

REMOVAL
1) Remove master cylinder.
2) Pull out retainer (1) and remove reservoir (2).
2
: Apply brake fluid to contact surface of cup.
: Confirm installing direction.
: Confirm installing direction.
BRAKES 5-33
Tightening torque
Do not reuse.