Rear Axle (2Wd Vehicle) - Suzuki Ignis Service Manual

3E-14 REAR SUSPENSION
9) Tighten front and rear trailing arm nuts (1), shock absorber
lower bolts (2) and lateral rod right nut (3) to specified torque
(right and left).
NOTE:
When tightening these nuts, be sure that vehicle is off
hoist and in no-loaded condition.
Tightening torque
Front trailing arm nut (a) : 90 N·m (9.0 kg-m, 65.0 lb-ft)
Rear trailing arm nuts (b) : 80 N·m (8.0 kg-m, 58.0 lb-ft)
Rear shock absorber lower bolts
(c) : 58 N·m (5.8 kg-m, 42.0 lb-ft)
Lateral rod right nut (d) : 65 N·m (6.5 kg-m, 47.0 lb-ft)

REAR AXLE (2WD VEHICLE)

REMOVAL
1) Hoist vehicle and remove rear wheels (right & left).
2) Support rear axle (1) using floor jack (2).
3) Remove rear brake drums (right & left). Refer to "BRAKE
DRUM" in Section 5.
4) Remove E-ring (1) (right & left) securing brake hose (2).
CAUTION:
Do not allow brake fluid to get on painted surfaces.