Table of Contents
Advertisement
INSTALLATION
1) Install coil springs (1) (right & left) on spring seat (2) of rear
axle (2WD vehicle) or rear axle housing (4WD vehicle) and
raise rear axle (2WD vehicle) or rear axle housing (4WD
vehicle).
NOTE:
Upper and lower diameters of coil spring are different.
Bring larger diameter end at bottom and set its open end
in place on spring seat.
A : Upper side
2) Install shock absorber (1) lower side to rear axle (2WD vehi-
cle) or rear axle housing (4WD vehicle).
Tighten shock absorber lower bolt (2) temporarily at this
step.
3) Remove floor jack from rear axle (2WD vehicle) or axle
housing (4WD vehicle).
4) Install brake flexible hose E-ring.
5) Install LSPV spring to rear axle (2WD vehicle) or axle hous-
ing (4WD vehicle). Tighten LSPV adjust nut temporarily at
this step (if equipped with LSPV).
6) Install lateral rod (1) right side to vehicle body, refer to the
figure for proper installing direction of bolt (2).
Tighten nut (3) temporarily at this step.
7) Remove floor jack from rear axle (2WD vehicle) or rear axle
housing (4WD vehicle).
A : Forward
8) Install wheel (1) and tighten wheel nuts (2) to specified
torque.
Tightening torque
Wheel nuts (a) : 85 N·m (8.5 kg-m, 61.5 lb-ft)
REAR SUSPENSION 3E-9
Advertisement
Table of Contents
