Chapter 7: Lubricating The Rotary Disc Pull-Type; Opening Driveshields - MacDon R113 Assembly Instruction Manual

Chapter 7: Lubricating the Rotary Disc Pull-Type

The rotary disc pull-type has been lubricated at the factory. However, you should lubricate the rotary disc pull-type prior to
delivery to offset the effects of weather during outside storage and transport.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.

7.1 Opening Driveshields

Driveshields protect people from rotating belts and drives.
WARNING
To reduce the risk of personal injury, do NOT operate the machine without the driveshields in place and secured.
NOTE:
Images shown in this procedure are for the left driveshield—the
right driveshield is similar.
1. Shut down the engine, and remove the key from the ignition.
2. Remove lynch pin (A) and tool (B) from pin (C).
215585
Figure 7.1: Left Driveshield
Figure 7.2: Left Driveshield
129
Revision A