Gth Transceivers - Xilinx ZCU102 User Manual

Figure 3-34 shows the power and status LEDs.
X-Ref Target - Figure 3-34

GTH Transceivers

[Figure 2-1, callout 1]
The Zynq UltraScale+ MPSoC has 24 GTH gigabit transceivers (16.3 Gb/s capable) on the
PL-side.
The GTH transceivers in the XCZU9EG device are grouped into four channels referred to as
Quads. The reference clock for a Quad can be sourced from the Quad above or Quad below
the GTH Quad of interest. There are six GTH Quads on the ZCU102 board with connectivity
as shown here:
• Two of the GTH transceivers are wired to the FMC0 HPC connector (J5)
• Two of the GTH transceivers are wired to the FMC1 HPC connector (J4)
ZCU102 Evaluation Board User Guide
UG1182 (v1.2) March 20, 2017
Figure 3-34: Power and Status LEDs
www.xilinx.com
Chapter 3: Board Component Descriptions
Send Feedback
79