Ti Msp430 System Controller - Xilinx ZCU102 User Manual

The system controller user interface allows the FMC IPMI routine to be overridden and an
explicit value can be set for the VADJ_FMC rail. Override mode is useful for FMC mezzanine
cards that do not contain valid IPMI EPROM data defined by the ANSI/VITA57.1
specification.

TI MSP430 System Controller

[Figure 2-1, callout 18]
The ZCU102 board includes an on-board MSP430 with integrated Power Advantage demo
and System Controller firmware. A Host PC resident system controller user interface (SCUI)
is provided on the
programmable features such as clocks, FMC functionality, power systems, and the Zynq
UltraScale+ MPSoC GTR selection compatible with your design. The ZCU102 web page also
includes a tutorial on the SCUI (XTP433)
[Ref 12]. The following briefly summarizes these instructions:
1. Ensure that the Silicon Labs VCP USB-UART drivers are installed.
2. Download the SCUI Host PC application.
3. Connect the micro-USB to ZCU102 USB-UART connector (J83).
4. Power-cycle the ZCU102.
5. Observe that SYSCTLR LED0 (DS47) blinks and LED1 DS46 is illuminated.
6. Launch the SCUI.
The SCUI GUI is shown in
ZCU102 Evaluation Board User Guide
UG1182 (v1.2) March 20, 2017
ZCU102 web page. This GUI enables you to query and control select
[Ref 11]
Figure 3-40.
www.xilinx.com
Chapter 3: Board Component Descriptions
and board setup instructions (XTP435)
Send Feedback
105