Xilinx ZCU102 User Manual page 106

X-Ref Target - Figure 3-40
On first use of the SCUI, go to the FMC > Set VADJ > Boot-up tab and click USE FMC
EEPROM Voltage. The SCUI buttons grey-out during command execution and return to
their original appearance when ready to accept a new command.
See the System Controller Tutorial (XTP433) and the ZCU102 Software Install and Board
Setup Tutorial (XTP435) for more information on installing and using the System Controller
utility.
The MSP430 uses ID resistor encoding to allow the System Controller utility awareness of
which board type is active. See
R516 and R517.
Table 3-54: MSP430 Board ID Encoding
Zynq UltraScale+
Board
ZCU102
ZCU106
Reserved
Reserved
The MSP430 firmware might be updated in the event new capability is added in the future.
Note:
The MSP430 upgrade header, J164, is reserved for this purpose. Xilinx will provide information on the
update procedure via future updates to XTP433
ZCU102 Evaluation Board User Guide
UG1182 (v1.2) March 20, 2017
Figure 3-40: SCUI Graphical User Interface
Table 3-54 for the configuration of the ID encoding resistors
R516 R517
DNP DNP
DNP 10K
10K DNP
10K 10K
[Ref
www.xilinx.com
Chapter 3: Board Component Descriptions
11].
Send Feedback
106