Xilinx ZCU102 User Manual page 18

Table 2-3: Default Jumper Settings (Cont'd)
Jumper
USB ULPI Device or Host select
J7 • 1-2: HOST/OTG
• Open: Device
USB ULPI Device/Host or OTG select
J113 • 1-2: Device or Host
• 2-3: OTG
ARM Trace VTREF
J88 • 1-2: 3.3V
• Open: 0V
ARM Trace power
J38 • 1-2: 3.3V
• Open: 0V
Power inhibit
J153 • OFF: rails power on normally
• 1-2: all rails (except UTIL) OFF
PS_DDR4_VPP_2V5 power inhibit (U39)
J9 • OFF: rail powers on normally
• 1-2: PS_DDR4_VPP_2V5 OFF
J164 MSP430 firmware upgrade header
ZCU102 Evaluation Board User Guide
UG1182 (v1.2) March 20, 2017
Function
www.xilinx.com
Chapter 2: Board Setup and Configuration
Figure 2-2 Schematic
Default
Callout Page
OPEN 20
1-2 21
1-2 22
1-2 23
OFF 24
OFF 25
OFF 26
51
51
54
54
59
77
38
18
Send Feedback