Running The Gth Ibert Demonstration; Connecting The Gth Transceivers And Reference Clocks - Xilinx Virtex-7 FPGA VC7222 IBERT Getting Started Manual

Chapter 1: VC7222 IBERT Getting Started Guide

Running the GTH IBERT Demonstration

The GTH IBERT demonstration operates one GTH Quad at a time. This section describes
how to test GTH Quad 115, while the remaining GTH Quads are tested following similar
steps.

Connecting the GTH Transceivers and Reference Clocks

Figure 1-1
board.
Note:
X-Ref Target - Figure 1-1
8
Send Feedback
shows the locations for all the GTH transceiver Quads on the Rev. B VC7222
Figure 1-1 is for reference only and might not reflect the current revision of the board.
Figure 1-1: GTH Quad Location
www.xilinx.com VC7222 IBERT Getting Started Guide
UG971 (v5.0) June 12, 2014