Language; Programming - BONFIGLIOLI ACTIVE CUBE 201 Operating Instructions Manual

10.8

Language

The parameters are stored in the frequency inverter in various languages. The parameter description
is displayed by the PC control software (e.g. VPlus) in the selected
Language 33
0 - Deutsch
1 - English
2 - Italiano
100 -
Up to ACU Firmware 5.1.11, the language is set via
ACU Firmware Version 5.2.0, the parameter texts are managed by the VPlus PC
software. If
As from Firmware Version 5.2.0, you will need a suitable VPlus Version (VPlus 7.38 or
higher).
10.9

Programming

Parameter 34 enables acknowledgment of a error signal and resetting to the factory
Program
settings. The display of the control unit reads "dEFLt" or "rESEt" and the LEDs indicate the status of
the frequency inverter.
Program 34
111 - Parameter transfer
Standard
110 -
operation
123 - Reset
4444 - Default
Parameters
default setting
120
Parameter description in German
Parameter description in English
Parameter description in Italian
The Language is set via VPlus (ACU Firmware as from 5.2.0)
33 is set to 100, settings 0,1 and 2 are disabled.
Language
Control unit P 500 is prepared for parameter transmission. A connected
frequency inverter can receive data from the control unit.
Resetting of control unit KP 500 to standard operation mode.
The current error message can be acknowledged via digital input
S1IND/STOA or the software parameter. The display of the control unit
reads "rESEt".
The parameters of the selected configuration, except for a few
exceptions, are reset to the default settings. The display of the control
unit reads "dEFLt".
28 and
Control Level
34 = 4444).
(Program
Operating Instructions ACU
Language
Function
Language
Function
30 are not changed when reset to
Configuration
33.
33 = 0,1,2, as from
12/16