Dimensions/Weight; Transfer To Place Of Installation; Unpacking The Device; Bringing The Device Into Installation Position - BONFIGLIOLI ACTIVE CUBE 201 Operating Instructions Manual

3.3

Dimensions/weight

For information on the weight and dimensions of the frequency inverter, refer to chapter 5
"Technical data".
3.4

Transfer to place of installation

Transfer to the place of installation is done with the product in its original packaging. Frequency
inverters as from size 7 must be transferred to the place of installation in horizontal position, rear-side
down. A fork lift truck or crane with crane fork can be used for transfer to the place of installation.
 Apply the fork in the middle of the transport unit.
 Secure the transport unit to prevent it from falling down and overturning.

Lift the transport unit up carefully.
 At the place of installation, put the transport unit down on a level and bearing surface.
3.5

Unpacking the device

 Carefully remove packaging.
 Check if the delivered devices corresponds to the order.
 Check the device for transport damage and completeness.
 Any defects/damage must be reported to the supplier immediately.
Ensure that all packaging materials are disposed of in an environmentally compatible
manner.
3.6

Bringing the device into installation position

3.6.1

Sizes 1 through 6

 Depending on the weight, one or two persons are required for lifting the device into the
installation position in the electrical cabinet. Installation, see Chapter 6 "Mechanical installation".
3.6.2

Sizes 7 and 8


Fix two crane eyes (M8) in the marked threaded holes on the top side of the device.
 Use appropriate lifting means.
12/16 Operating Instructions ACU 25