BONFIGLIOLI ACTIVE CUBE 201 Operating Instructions Manual page 167

If a digital input is configured as a PWM or repetition frequency input, this input
cannot be used for other functions.
Check the link of the digital inputs to other functions.
The signal frequency at the selected repetition frequency input can be scaled via the parameter
497. The parameter value can be compared to the number of division marks of an encoder
Divider
per rotation of the drive. The frequency limit of the parameterized digital input is to be taken into
account for the frequency of the input signal.
Parameter
No. Description
497 Divider
The reference value specification within the different functions enables the use of the
repetition frequency signal as a percentage figure. A signal frequency of 100 Hz at the
repetition frequency input corresponds to 100%, 1 Hz corresponds to 1%. The
parameter
simulation.
Via parameters
Offset
application.
Parameter
No. Description
652 Offset
653 Amplification
PWM-Signal
PWM  Value  652
Offset
For definition of reference values, the following settings are possible:
 For reference frequencies:
Reference Frequency Source
the signal is referred to
 For reference percentages:
Reference Percentage Source
the signal is referred to
The actual value of the PWM input is shown in parameter
12/16
Min.
497 is to be used in a way comparable with the speed sensor
Divider
652 and
Amplification
Min.
-100.00%
5.0%
T
ON

 
T
on
  
% Amplificat

T
ges
475 = "32 - Abs. value/PWM Inp. (F3)". The PWM-value for
Maximum Frequency
476 = "32 - Abs. value/PWM Inp. (F3)". The PWM-value for
Maximum Reference Percentage
Operating Instructions ACU
Setting
Max.
1 8192
653 the PWM input signal can be adjusted for the
Setting
Max.
100.00%
1000.0%
T
ges

653 
ion

419.
519.
PWM-Input
Factory setting
1024
Factory setting
0.00%
100.0%
t
258.
167