Setting Frequency - BONFIGLIOLI ACTIVE CUBE 201 Operating Instructions Manual

16.3.2

Setting Frequency

If Operation Mode 4 - "Setting Frequency" is selected for a digital output , the relevant output will
be active once the actual value
510.
The output will be switched again once the
510 minus
Frequency
(e.g. via STO), the digital signal "Setting Frequency" is set to zero, regardless of the actual
frequency.
Signal source 164 - "Setting frequency" can be linked to the functions of the frequency inverter.
Parameter
No. Description
510 Setting Frequency
517 Setting Frequency Off Delta
Stator Frequency
Digital output
164 - Setting Frequency
Once
Setting Frequency Off Delta
turned off anymore after first activation. Make sure you use suitable values during
parameterization.
Op. Mode Digital Output 1
Op. Mode Digital Output 2
Op. Mode Digital Output 3
With extension module:
Op. Mode EM-S1OUTD
Op. Mode EM-S1OUTD
Setting Frequency510
For linking to functions
12/16
Stator Frequency
Stator Frequency
Setting Frequency Off Delta
210
530
or
531
or
532
533
or
534
Operating Instructions ACU
210 is higher than the value of
210 drops below the value "
517". Once the output stages are switched off
Setting
Min. Max.
0.00 Hz 599.00 Hz
0.00 Hz 599.00 Hz
Setting Frequency
Setting Frequency Off Delta
t
517 >
Setting Frequency
4 - Setting frequency
set value [Hz].
164 - Setting frequency
Setting Frequency
Setting
Factory setting
3.00 Hz
2.00 Hz
510
517
510, the output will not
179