Output Characteristic; Frequency Output Mfo1F - BONFIGLIOLI ACTIVE CUBE 201 Operating Instructions Manual

Analog Operation 553
54 - Pressure
101 to 133

16.2.1.1 Output Characteristic

The voltage range of the output signal at multifunction output 1 can be adjusted. The value range of
the actual value selected via
output signal which is adjusted via the parameters
Parameter
No. Description
551 Voltage 100%
552 Voltage 0%
553 with abs. actual
Analog Operation
value:
+ 2 4 V
+ 1 0 V
0 V
0 %
5 0 %
With parameters
Voltage 100%
the output parameter is set. If the output value exceeds the reference value, the output voltage also
exceeds the value of the parameter
16.2.2

Frequency Output MFO1F

Multifunction output MFO1 can be used as a frequency output by setting parameter
550 = "3 - Repetition Frequency". The DC 24 V output signal is assigned to the absolute
Mode
speed/frequency value via parameter
operation modes depends on the extension modules installed as an option.
Repetition Freq. Operation
555
0 - off
1 - Actual frequency
2 - Stator Frequency
3 - Frequency Speed Sensor 1
5 - Repetition frequency input
174
Abs. value of calculated pressure
0.0 kPa ...
Nominal Pressure
Operation modes in analog operation with signs.
parameter Analog Operation
Voltage 100%
Min.
0.0 V
0.0 V
Analog Operation
+ 2 4 V
+ 1 0 V
+ 5 V
0 V
1 0 0 %
- 1 0 0 %
551 and
Voltage 0%
551 up to the maximum value of 24 V.
Voltage 100%
Repetition Freq. Operation
Repetition frequency operation MFO1 switched off
Abs. value of
Actual Frequency
Abs. value of
Stator Frequency
Abs. value of
Encoder 1 Frequency
Abs. value of
Repetition Frequency Input
Operating Instructions ACU
Function
398.
553 is assigned to the value range of the
551 and
Voltage 0%
Setting
Max. Factory setting
22.0 V
24.0 V
553 with sign:
0 % 1 0 0 %
552 the voltage range at 100% and 0% of
555. The selection of the
Function
241.
210.
217.
252.
552.
10.0 V
0.0 V
Operation
12/16