Selecting And Configuring S/5 Network - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

The network configurations will be saved and become active when the patient monitor is
restarted.

7.2.3 Selecting and configuring S/5 Network

To select S/5 Network for the real-time network infrastructure:
1. Log in to Webmin.
2. Select Configuration > Network > Wired Interfaces.
The current network configuration is shown in the Present Configuration table.
3. Below Select Network Type in the Network Configuration window, select the applicable
network type: S/5.
4. Select Next to proceed on network configuration.
NOTE: When S/5 Network is selected, the CARESCAPE Network is disabled.
The patient monitor may be configured to the S/5 Network, or IX Network, or both.
Network connection(s)
S/5 Network only
IX Network only
Both S/5 and IX Network
1. In the Network Configuration window below S/5 Network, enter a Virtual ID.
NOTE: Valid values are within the range of 50000 to 55000, inclusive.
NOTE: The Virtual ID must be unique for each patient monitor connected to the S/5 Network.
2. Below IX Network, select DHCP or Manual Configuration.
a.
b.
c.
d.
3. Select the applicable Speed & Duplex option.
4. Select Save.
The S/5 virtual ID change will be applied immediately. All other network configurations will be
saved and become active after the patient monitor is restarted.
7.2.4 Configuring WLAN
NOTE: The network infrastructure selection, MC Network or S/5 Network, and related
configuration shall be completed prior to configuring the WLAN settings.
NOTE: Wireless communication is supported only in CARESCAPE Network MC and S/5 Network.
CARESCAPE Network IX does not support wireless communication.
1. Log in to Webmin.
2. Select Configuration > WLAN. The current status of the WLAN radio is shown below the
Current State in the WLAN Configuration window.
3. Select Enable as a New State to enable the WLAN radio.
NOTE: If the WLAN radio is disabled, the WLAN radio is turned off.
4. Select Antenna as Enabled to enable both the internal antennas.
Enter a Static IP address.
Enter a valid Netmask level.
Enter a valid Default Gateway.
Enter valid DNS Server addresses if applicable.
Steps to be performed
1 and 4
2, 3 and 4
1, 2, 3 and 4
Configuration
71
2081903-001