Installing The Battery Into The Patient Monitor - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

CARESCAPE Monitor B650
−
Three LEDs illuminated: 50% – 74.9% of full-charge capacity.
− Two LEDs illuminated: 25% – 49.9% of full-charge capacity.
− One LED illuminated: 10% – 24.9% of full-charge capacity.
− One LED flashing: < 10% of full-charge capacity remaining.
NOTE: Before taking the patient monitor into use for the first time, the battery should be fully
charged. Keep the PDM connected to the patient monitor and the patient monitor connected to
the AC mains until the batteries are fully charged.

6.1.2 Installing the battery into the patient monitor

1. Open the battery cover by turning the battery cover lock 90 degrees clockwise.
2. Insert the battery with the test indicator side up and the connector end first all the way
into the battery slot. To remove the battery, pull it out from the cord.
3. Push the cover back up and lock it in place by turning the lock 90 degrees
counter-clockwise.
6.1.3 Installing the battery into the PDM module
1. Open the battery door by gently pulling on the battery door pull tab.
2. Pull the battery tray out of the PDM using the battery tray strap.
3. Insert the battery with the
58
2081903-001
TEST
button facing up and the arrow pointing into the PDM.