GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual page 72

CARESCAPE Monitor B650
devices, the user must contact the manufacturers concerned (or other
informed experts) for proper use. In all cases, safe and proper operation
should be verified with the applicable manufacturer's instructions for use,
and system standards IEC60601-1-1 must be complied with.
When interfacing the device with other equipment, the devices may only be interconnected
with each other or to parts of the system when it has been determined by qualified biomedical
personnel that there is no danger to the patient, the operator, or the environment as a result.
WARNING Do not under any circumstances remove the grounding conductor from the
power plug. Always check that power cord and plug are intact and
undamaged.
WARNING POWER SUPPLY — The device must be connected to a properly installed
power outlet with protective earth contacts only. If the integrity of the
protective earth conductor is in doubt, disconnect the monitor from the
power line, and use it with the battery option, if available. All devices of a
system must be connected to the same power supply circuit. Devices which
are not connected to the same circuit must be electrically isolated when
operated.
CAUTION POWER REQUIREMENTS - Before connecting the device to the power line, check
that the voltage and frequency ratings of the power line are the same as those
indicated on the device's label. If this is not the case, do not connect the system
to the power line until you adjust the device to match the power source. In
U.S.A., if the installation of this equipment will use 240V rather than 120V, the
source must be a center-tapped, 240V, single-phase circuit. This equipment is
suitable for connection to public mains as defined in CISPR 11.
If a non-medical grade display is used as a display within the patient environment it must
always be powered from an additional transformer providing at least basic isolation.
1. Connect power cords to the mains power supply inlet and to a wall outlet on all system
components that require AC mains power input.
2. Do not power on any devices.
NOTE: Be sure that all power cords are securely connected and that they are routed through
the retaining clips or cable clamps, as applicable.
64
2081903-001