Error Messages And Codes - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

CARESCAPE Monitor B650
Field
Battery Quality
2. For more detailed information, select Advanced tab.
Field
Remaining capacity (mAh)
Full capacity (mAh)
Full capacity compared to new (%)
Cycle count
Voltage (V)
Current (mA)
Temperature (°C or °F)
NOTE: Refer to the Module Frames and Modules Technical Manual for information about PDM
battery.

11.7 Error messages and codes

The following error messages display in the message field if there is a problem with the patient
monitor.
Refer to the patient monitor's user's manual for a complete list of system messages. Refer to
Module Frames and Modules Technical Manual for a list of parameter module specific error
messages.
Message
License expired
Configuration
changes. Restart
required
Network down
154
2081903-001
Status Description
"OK" The full capacity of the battery is more than
50% compared to the full capacity of a new
battery.
"Condition" Battery requires conditioning.
"Replace" The full capacity of the battery is less than or
equal to 50% compared to the full capacity of a
new battery.
"N/A" Battery is not connected to the patient monitor.
Description
Remaining capacity of the battery in mAh.
Full capacity of the battery in mAh.
Full capacity of the battery compared to the
nominal full capacity of a new battery.
The total count of charging and discharging
cycles of the battery.
Battery voltage.
Battery current. Positive when charging,
negative when discharging.
Battery temperature.
Possible causes
A trial license has expired.
Pending configuration
changes to platform settings
that require patient monitor
restart.
No other network device
observed on the MC Network.
Possible solutions
Enable the license with a new
activation code, if needed.
Power cycle the patient monitor.
Verify that the patient monitor is
connected to an active network.