Pre-Installation Requirements - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

5

Pre-installation requirements

This chapter specifies the pre-installation requirements for the patient monitor.
5.1 Unpacking
1. Confirm that the packing box is undamaged. If the box is damaged, contact the shipper.
2. Open the top of the box and carefully unpack all components.
3. Confirm that all components are undamaged. If any of the components is damaged,
contact the shipper.
4. Confirm that all components are included. If any of the components is missing, contact
your GE Healthcare distributor.
WARNING EXCESSIVE LEAKAGE CURRENT - If the device has been transported or stored
outside operating temperature range allow it to stabilize back to operating
temperature range before removing it from the plastic bag.
CAUTION PACKAGING DISPOSAL - Dispose of the packaging material, observing the
applicable waste control regulations.
5.2 Compatibility check
Verify the compatibility of all system components prior to the installation of the patient
monitor.
• Refer to the patient monitor's supplemental information manual for a list of compatible
network and bedside devices.
• Refer to the patient monitor's supplemental information manual for a list of compatible
supplies and accessories.
• Refer to the patient monitor's supplemental information manual and Unity Network
Interface Device (ID) Operator's Manual to see compatible peripheral devices.
WARNING BEFORE INSTALLATION - Compatibility is critical to safe and effective use of
this device. Please contact your local sales or service representative prior to
installation to verify equipment compatibility.
WARNING INTERFACING OTHER EQUIPMENT - Connect only items that are specified as
part of the system and as compatible. For more information, see the
CARESCAPE Modular Monitors Supplemental Information Manual.
WARNING Before connecting an interfacing module to the device, verify compatibility.
Verify the connectivity of device interfaces before using the equipment.
Verify the compatibility of software versions before using the equipment.
WARNING Do not use identical measurement modules or modules that map a
measurement to the same channel or parameter window. If such modules
have been connected, remove the module that has been most recently
connected. You can also remove both modules and re-connect the new
module after five seconds.
Pre-installation requirements
2081903-001
51