Alphanumeric Keyboard - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

CARESCAPE Monitor B650

10.3.7 Alphanumeric keyboard

Follow the procedure in section
10.3.8 Barcode reader
Follow the procedure in section
10.3.9 MC Network and S/5 Network
Follow the procedure in section
10.3.10
Wireless LAN
Follow the procedure in section
10.3.11 IX printers
Follow the procedure in section
10.3.12 Insite with Exc
Follow the procedure in section
10.3.13 Recorder
1. Select Monitor Setup > Printing > Devices > Setup and configure:
Printout: Waveforms
Location: Local
2. Select Monitor Setup > Printing > Waveforms and configure:
Waveform 1: II
Waveform 2: V1
3. Select Monitor Setup > Printing > Waveforms > Print Waveforms or the related soft key
in the main menu, or the Print Waveforms hard key in the keypad to start printing.
4. Verify that the recorder starts printing. Let the recorder print for approximately 10
seconds and verify the following things from the printout:
−
−
−
Stop printing by selecting Monitor Setup > Printing > Waveforms > Stop Printing, or the
related soft key in the main menu.
10.3.14 Synchronization connector test
Perform this test only if an E-PSM(P)(W) or an E-(P)RE(S)TN module is in use with the patient
monitor.
NOTE: This test can't be performed with a PDM module. If the patient monitor is only used with
a PDM module, the synchronization connector test is not applicable.
132
2081903-001
8.3.7. Alphanumeric
8.3.8. Barcode
8.3.9. MC Network and S/5
8.3.10. Wireless
8.3.11. IX
8.3.12. Insite with EXC
The header line contains the date, time and some other applicable status and
configuration information.
The grid is clear.
The waveforms labels appear in the printout as configured.
keyboard.
reader.
Network.
LAN.
printers.