Table of Contents
Advertisement
CARESCAPE Monitor B650
Configuring the patient simulator:
Refer to the simulator documentation for details on how to use and configure the simulator.
6.
Configure the patient simulator to output ECG waveform with:
−
−
−
Configuring the patient monitor:
7.
Configure the ECG1, ECG2 and ECG3 waveform fields to the monitor screen with
adequate priority.
8.
In the Parameter Setup > ECG > Setup, select:
−
−
−
9.
Start a patient case / admit a patient in Data & Pages > Admit/Discharge menu.
10. Select Data & Pages > Other Patients. Select the unit and bed name of the stationary
monitor and then select View.
Configuring the service PC:
11. Login to Webmin.
12. Select Diagnostics > WLAN.
NOTE: The WLAN information shown in Webmin Diagnostics page is static. Press
the web browser and to see up-to-date WLAN diagnostics data.
Test execution
Execute the test procedure according to the test plan. Contact the nursing staff to ensure
access to the needed areas before starting the test.
1.
Move the roll cart to the starting point of the planned test route.
2.
Stop at each test point and perform the following tasks:
a.
On the transport monitor:
•
b.
On the service PC: Refresh Webmin view by selecting
•
•
•
c.
Mark the network time, RSSI and Transmit Rate to the test form.
d.
If there is a waveform loss situation or the RSSI or the Transmit Rate is lower than
specified:
•
C - 4 (6)
2081903-001
ECG rhythm: a normal sinus rhythm
Heart rate: 80 bpm
Amplitude: 1 mV
ECG1 lead: II
ECG2 lead: V1
ECG3 lead: aVL.
Verify that ECG waveforms from the remote, stationary patient monitor display in
the bed-to-bed view without any losses.
Identify the Access Point the patient monitor is connected to.
Verify that the Signal level (RSSI) in dBm is greater than or equal to -60 dBm.
Verify that the Transmit Rate in Mbps is greater than or equal to 5.5 Mbps.
Observe the length of the waveform loss and, if possible, potential cause of it, for
example roaming or out of range situations.
F5
F5
and:
to refresh
Hide quick links:
Advertisement
Table of Contents
