Deleting A Printer - GE HEALTHCARE CARESCAPE Monitor B650 Technical Manual

CARESCAPE Monitor B650
4. Below Printer Configuration Information in the Install Printer window, provide the
following information:
a.
b.
c.
d.
5. Select Save.
6. From the patient monitor, select Monitor Setup > Printing.
7. Select the Devices > Setup.
8. In the Printout menu, select what to print out (for example, Waveforms, Alarm
Waveforms, Numeric Trends, Reports).
9. Below Location, select the radio button next to Network.
10. From the drop down list next to Network Device, select the desired printer.
The change will take effect immediately.

7.5.2 Deleting a printer

NOTE: Before deleting a laser printer, check Monitor Setup > Printing > Devices > Status. If a
printout is assigned to the printer to be deleted, redirect the printout to another valid printer.
1. Log in to Webmin.
2. Select Configuration > Printers.
3. In the Sub-Modules for Printers menu, select Delete Printer.
4. In the Delete Printer window, select the printer to delete.
5. Select Save.
The change will take effect immediately.
7.5.3 Printing a test page
1. Log in to Webmin.
2. Select Configuration > Printers.
3. In the Sub-Modules for Printers menu, select Print Test Page.
4. In the Print Test Page window, select the printer.
5. Select Save.
7.6 Configuring MUSE/12SL
NOTE: MUSE viewing and the related configuration settings are available only if the monitor is
equipped with the Advanced Interface Board that provides both the MC and the IX Network
interfaces.
NOTE: MUSE viewing is a licensed software feature. You can configure the MUSE/12SL settings
independent of the license status, but actual viewing of MUSE reports requires that the
MuseView license is enabled.
Settings to send 12SL data
1. Log in to Webmin.
2. Select Configuration > MUSE/12SL.
3. In the MUSE/12SL window, enter the applicable information in the following fields:
78
2081903-001
Select either the Hostname or IP Address radio button, as applicable.
In the Hostname or IP Address field, enter the printer Hostname or IP Address.
In the Printer Name field, enter the Printer Name.
Select Yes from the drop down list next to Test Page.