How to Install aT1100 AS Frame
4. Insert the large washer, small washer, and torque nut onto the threaded rod on the inside of
the frame.
Be sure to leave at least 5 threads of threaded rod exposed on the inside of the frame. Tighten
the nuts above the raised floor.
Note: DO NOT over tighten, causing the tile or frame to tilt.
5. This procedure is complete.
Next, go to
How to Anchor to Overhead Rack of HD Frame
How to Anchor to Overhead Rack of HD Frame
Frames with shelves that extend must be attached to overhead racks to prevent toppling.
1. Using the Cable Rack Mounting kit with ladder hooks, threaded rods, and insulators, place
the assembly directly above the frame for overhead support.
2. Secure the top of the frame to the overhead racks using threaded rods with hardware as shown
in
Figure 43: HD Frame with Overhead Rack
Figure 43: HD Frame with Overhead Rack
66
on page 66.
on page 66.
910-2969-001 Revision K, June 2009
Hardware Manual