Configuring Outbound One-To-One Static Nat; Configuring Outbound Net-To-Net Static Nat - HPE FlexNetwork HSR6800 Configuration Manual

transport layer protocol, and VPN instance. For more information about ACLs, see ACL and
QoS Configuration Guide.
•
Manually add a route for inbound static NAT. Use local-ip or local-network as the destination
address, and use global-ip, an address in global-network, or the next hop directly connected to
the output interface as the next hop.

Configuring outbound one-to-one static NAT

For address translation from a private IP address to a public IP address, configure outbound
one-to-one static NAT on the interface connected to the external network.
•
When the source IP address of a packet from the private network matches the local-ip, the
source IP address is translated into the global-ip.
•
When the destination IP address of a packet from the public network matches the global-ip, the
destination IP address is translated into the local-ip.
To configure outbound one-to-one static NAT:
Step
1. Enter system view.
2. Configure a one-to-one
mapping for outbound static
NAT.
3. Return to system view.
4. Enter interface view.
5. Enable static NAT on the
interface.

Configuring outbound net-to-net static NAT

For address translation from a private network to a public network, configure outbound net-to-net
static NAT on the interface connected to the external network.
•
When the source IP address of a packet from the private network matches the private address
range, the source IP address is translated into a public address in the public address range.
•
When the destination IP address of a packet from the public network matches the public
address range, the destination IP address is translated into a private address in the private
address range.
To configure outbound net-to-net static NAT:
Step
1. Enter system view.
Command
system-view
nat static outbound local-ip
[ vpn-instance
local-vpn-instance-name ]
global-ip [ vpn-instance
global-vpn-instance-name ] [ acl
{ ipv4-acl-number | name
ipv4-acl-name } [ reversible ] ]
[ disable ]
quit
interface interface-type
interface-number
nat static enable
Command
system-view
121
Remarks
N/A
By default, no mappings exist.
If you specify the acl keyword,
NAT processes only packets
matching the permit rule in the
ACL.
N/A
N/A
By default, static NAT is disabled.
Remarks
N/A