Configuring Ppp; Ppp Configuration Task List; Enabling Ppp Encapsulation On An Interface; Configuring Ppp Authentication - HPE FlexNetwork MSR series Configuration Manual

•
MSR2003.
•
MSR2004-24/2004-48.
•
MSR3012/3024/3044/3064.
•
MSR954(JH296A/JH297A/JH298A/JH299A/JH373A).
•
MSR958(JH300A/JH301A).
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.

Configuring PPP

PPP configuration task list

Tasks at a glance
(Required.)
(Optional.)

Configuring PPP authentication

(Optional.) Configuring the polling feature
(Optional.) Configuring PPP negotiation
(Optional.) Enabling IP header compression
(Optional.) Enabling PPP link quality monitoring
(Optional.) Enabling PPP accounting
(Optional.) Configuring the nas-port-type attribute

Enabling PPP encapsulation on an interface

Step
1. Enter system view.
2. Enter interface view.
3. Enable PPP encapsulation
on the interface.
Configuring PPP authentication
You can configure several authentication modes simultaneously. In LCP negotiation, the
authenticator negotiates with the peer in the sequence of configured authentication modes until the
LCP negotiation succeeds. If the response packet from the peer carries a recommended
authentication mode, the authenticator directly uses the authentication mode if it finds the mode
configured.
Configuring PAP authentication
To configure the authenticator:
Enabling PPP encapsulation on an interface
Command
system-view
interface
interface-type
interface-number
link-protocol ppp
5
Remarks
N/A
N/A
By default, all interfaces except
Ethernet interfaces,
interfaces, and ATM interfaces
use PPP as the link layer protocol.
VLAN