Configuring Basic L2Tp Capabilities - HPE FlexNetwork MSR series Configuration Manual

Tasks at a glance
Configuring an
•
(Required.)
user
•
(Required.)
•
(Optional)
packets
•
(Optional.)
•
(Required.)
•
(Required.)
tunnel
(Optional.)
•
Configuring L2TP tunnel authentication
•
Setting the Hello interval
•
Enabling session flow control
•
Setting the DSCP value of L2TP packets
•
Assigning a tunnel peer to a VPN
•
Setting the TSA ID of the LTS
To configure a device as an LNS in NAS-initiated, client-initiated, or LAC-auto-initiated mode,
complete the following tasks:
Tasks at a glance
(Required.)
Configuring an
•
(Required.)
•
(Optional.)
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
•
Configuring L2TP tunnel authentication
•
Setting the Hello interval
•
Enabling session flow control
•
Setting the DSCP value of L2TP packets
•
Assigning a tunnel peer to a VPN
•
Setting the TSA ID of the LTS

Configuring basic L2TP capabilities

Basic L2TP capability configuration includes the following tasks:
•
Enabling L2TP—L2TP must be enabled for L2TP configurations to take effect.
•
Creating an L2TP group—An L2TP group is intended to represent a group of parameters.
This enables not only flexible L2TP configuration on devices, but also one-to-one and
one-to-many networking applications for LACs and LNSs. An L2TP group has local significance
only. However, the relevant settings of the L2TP groups on the LAC and LNS must match. For
example, the local tunnel name configured on the LAC must match the tunnel peer name
configured on the LNS.
LAC:
Configuring an LAC to initiate tunneling requests for a
Specifying LNS IP addresses
Configuring the source IP address of L2TP tunnel
Enabling transferring AVP data in hidden mode
Configuring AAA authentication on an LAC
Configuring an LAC to automatically establish an L2TP
Configuring optional L2TP
Configuring basic L2TP capabilities
LNS:
Creating a VT interface
Configuring a VA pool
Configuring an LNS to accept L2TP tunneling requests from an LAC
Configuring user authentication on an LNS
Configuring AAA authentication on an LNS
Configuring optional L2TP
parameters:
parameters:
74
Remarks
The first and fifth tasks are
required for NAS-initiated mode
and unnecessary
LAC-auto-initiated mode.
The last task is required for
LAC-auto-initiated mode
unnecessary for NAS-initiated
mode.
N/A
for
and