Using Applications With The Factory Settings; Creating New Tasks (Configuration) - Sartorius Cubis MSU116P User Manual

Task Management
D
®
68 Cubis MSU User Manual

Using Applications with the Factory Settings

Each application comes with specific factory settings.
If you want to apply these settings unchanged, you can do this quickly during
configuration:
t
Open Task Management and select
t
Select
Create.
y An application list is displayed.
t
Select the application you want to assign to the new task.
t
Select .
Done
t
Enter a name and a description for the task and select
y The new task is saved with the factory settings and displayed in the task list.
Sorting the Task List
New tasks are always added to the end of the task list. After you have configured
several tasks, it may be helpful to sort the task list.
D
y The task selection is displayed.
t
Select Sort .
y The list is sorted alphabetically (A – Z).
t
To reverse the sort order, select
t
To sort tasks by the date of last use, select

Creating New Tasks (Configuration)

®
The Cubis software contains the following applications that you can configure
as tasks as required:
– Weighing
– Mass unit conversion
– SQmin minimum weighing (optional) – Totalizing
– Individual identifiers
– Density determination
– Statistics
– Calculation
– Averaging
– Formulation
Edit .
Save
again.
Sort
again.
Sort
– Weighing in percent
– Timer-controlled functions
– DKD uncertainty of measurement (optional)
– Second tare memory (preset tare)
– Parts counting
– Checkweighing
– Draft shield (optional)
– Ionizer (optional)
.