Sartorius Cubis MSU116P User Manual page 106

Formulation
D
®
106 Cubis MSU User Manual
For all formulations, the following applies:
– The individual components can be stored manually or automatically
(first reproducible value).
– If automatic storage of values was selected, the minimum load is determined
when the task is created.
– After weighing the first component, the
you can change the display to show the intermediate result.
– Once the intermediate result is displayed, you can delete the value of the last
weighed component by selecting
Corr. and it will be removed from the calculation. This allows you to delete
all components step-by-step in reverse order. Deletion is irreversible!
– Use Back to toggle the display and continue the task.
– After the defined number of components has been weighed, the evaluation
is displayed. Here too, you can still delete the components (beginning with
the last component) and weigh them again.
Note: For the seventh formulation, there is no automatic evaluation because
the defined number of components is zero. You have to evaluate the measurement
manually by selecting Calc.
Configuring a Task: Formulation
* = factory setting
t
Define how the weight values will be applied.
*Manually : The weight value is applied as soon as the corresponding softkey
is pressed.
Automatically: first value at stability
matically as soon as the balance has stabilized. You must now select the minimum
load to be applied (
10, 20, ... *100 ... 1000 digits
t
Set when the number of components will be defined.
Enter fixed quantity : The number of components is defined beforehand.
*Quantity can be changed during process
nents only when you execute the task (Formulations 6 and 7).
option is displayed. That way,
Calc.
: The weight value is applied auto-
).
: Enter the number of compo-