Sartorius Cubis MSU116P User Manual page 20

Getting Started
®
20 Cubis MSU User Manual
Models with an External Electronics Module: Connecting the Weigh Cell to the
Electronics Module
t
Connect the weigh cell and electronics module using the connection cable:
Make sure that the connectors click into place so that both ends engage
correctly.
3
Check the plug contacts to ensure that the connection is correct.
There should be no tension on the connection cable, e.g. if pushed
directly against a wall.
t
Connecting the Weigh Cell to the Evaluation Unit:
Make sure that the connector clicks into place so that the cable is engaged.
3
Models with a separate electronics module (e.g. MSU66/36/6.6/3.6/2.7,
MSU225S/P, MSU125P and MSU116P):
Do not mix up the eletronics module.
Interchanging with, e.g. models of the ME/SE series will damage the
device.
Models MSU66 and MSU36: Placing components into weighing chamber
t
Insert the following components into the weighing chamber in the order given:
1. Shield disk
2. Weighing pan
3. Internal draft shield
3
2
1