Configuring Printouts - Sartorius Cubis MSU116P User Manual

In the System Settings (Menu)
Creating Tasks
Printout (Example):
Printout interface
Protocol (operating mode)
Output
Printout criterion
Format auto. print
Standard data output
GLP printing
Print event
Print elements
Tare after printing:

Configuring Printouts

You can configure the printout at two places; for example, you can have the printout
for basic weighing differ from all the other applications.
You define the basic settings in the menu. Previously created tasks will not be
affected by modifications to the basic settings.
This is where you can specifically modify the user-defined settings for any task. You
will be routinely prompted for the printer settings with every new task you create
and can then modify them.
Print events Printout content (record)
Start task ------------------
21.02.2017 09:17
SARTORIUS
Mod. MSU 224S
Ser. no. 12-34-56
------------------
Start task Laboratory
e.g. here: technician
Start task Product...........
P key
123.5678g
------------------
21.02.2017 09:20
End task
Name:
------------------
Settings for Printouts
During printout configuration the following parameters are defined:
Peripheral ports (Com A), USB/PC (Com B), optional interface (Com C), Ethernet
(Com D)
Depends on the interface: Print, SBI, xBPI, SICS
Depends on the operating mode: Single printout or automatic print (not with
printer), with/without stability. For "Autom. Print" for the fasted display result,
set additional software handshake or no handshake.
Manual without stability, manual with stability
22 characters for applications, 16 characters for raw data
Standard 1 (measured value only), Standard 2 (measured value and date/time),
Standard 3 [date/time, weight block (N,T,G), and dotted line]
Off, no GLP printout / For calibration/adjustment only / Always on
Defines which event should trigger a print job.
The selectable print events depend on the selected application.
For basic weighing: P key, start or end of task, calibration/adjustment result.
For calculating applications: additional initialization and result.
For logging applications: additional component and evaluation
The elements to be printed also depend on the selected application. Define the
print elements for each each event, e. g., date and time, dotted line, measured
value, and the sequence in which they should be printed, etc.
Off, no tare / On (automatic tare after print request)
Task Management
Print elements
GLP header
Operator name
ID1, identification: fixed/variable
Measured values
GLP footer
®
Cubis MSU User Manual 71