Anti-Theft Locking Device; Leveling - Sartorius Cubis MSU116P User Manual

Getting Started
R
L
R
L
L
®
26 Cubis MSU User Manual
Anti-Theft Locking Device (Accessory)
Balances with a readability of 0.01 mg:
t
An anti-theft locking device can be installed to the back of the balance if
required.
Balances with a readability of 1 μg:
To fasten the anti-theft locking device, use the lug located on the back of the
weigh cell.

Leveling

h
Leveling the balance compensates for slant or unevenness at the
place of installation. The scale must be perfectly horizontal to ensure
consistent, reproducible weighing results. All models are equipped with
an electronic tilt angle detection feature. If the balance is not level, a
warning message appears on the display.
Push-button automatic leveling is available on models with motorized
leveling feet. For models with manual leveling feet, please follow the
instructions on the display.
Leveling the Balance Manually
y The scale is leveled using both front leveling feet.
t
Screw in both back leveling feet (only for models with back leveling feet).
t
Turn the front leveling feet as shown in the illustration until the air bubble is
R
centered within the circle of the level indicator.
y Normally, several leveling steps are required
t
Turn both back leveling feet until they touch the setup surface (only for models
with back leveling feet).