Sartorius Cubis MSU116P User Manual page 153

Configuring Network Operation (Ethernet)
Preparation: Before you can start with the configuration, you will require some information
about your network. Please contact your network administrator. The important
question is whether your network supports DHCP or not.
DHCP With DHCP, you can automatically link a (new) balance to an existing network
without having to configure it manually. Normally, the balance (client) only
requires the automatic acquisition setting for IP address (factory setting).
DHCP is supported In this case, no additional information is required.
DHCP is not supported In this case, you need the following information from the network administrator:
– IP address
– Subnet mask
– Default gateway address
Selecting Network Setting (Fixed Setting)
t
t
t
t
t
t
t
t
t
y The "Configure ports" submenu is displayed.
Device name (host name): This name can be changed if required.
This name is used to select the balance in the network.
If appropriate, toggle to the System Settings menu.
Select the
Device parameters
right scroll bar down.
Select
Configure ports
Open the Network settings (Ethernet)
To change the IP settings, select the input field behind
Network configuration
Select Use fixed IP address
In the overview, check all settings and change as required.
Device name (host name): You can select this name freely.
This name is used to select the balance in the network.
If you then want to establish an Ethernet connection, write down the IP
address now.
To save the network settings, select
submenu and slide the
.
submenu.
.
and confirm with OK .
Save .
®
Cubis
Interfaces
MSU User Manual 153