Sartorius Cubis MSU116P User Manual page 29

2
1
3
2
1
1
t
Turn over the balance and place on a soft surface.
3
Exercise caution to avoid breaking the glass on models with a draft shield.
t
Use a 2.5 mm Allen wrench to remove the two screws from the display and
control unit retainer bracket.
t
Remove the display and re-insert both screws back into their holes.
t
Lengthen the cable and position the display and control unit as desired.
t
Turn the balance over and place it on an even surface.
t
Carefully place all parts on the balance.
1. Shield plate/Draft shield
2. Pan support (not for models MSU225.../MSU125...)
3. Weighing pan
t
Remove the upper draft shield
panel.
2
Models with the analytical draft shield
(left illustration):
1. Press on the locking tab
2. Remove the panel
Models with the milligram draft shield
(right figure):
1. Press on the locking tab
2. Remove the panel
t
Keep all parts in a safe place.
Cubis
Getting Started
®
MSU User Manual 29