Network Interface (Ethernet) - Sartorius Cubis MSU116P User Manual

System Requirements
1
2

Network Interface (Ethernet)

Purpose This interface lets you integrate your balance into a TCP/IP-based network.
The person configuring the Ethernet interface should have basic knowledge of TCP/
IP-base networks and network technologies in general.
The Ethernet interface is connected to the local network via the RJ45 slot.
Features
Transfer rate:
Connection type:
Transport:
HMS certificates:
Cable:
Cable impedance:
Cable length to HUB:
Connecting Network Cables
The slot for the network port is located at the back of the control unit.
t
Tilt the control unit (1) until it is nearly vertical.
On the bottom panel of the display unit:
t
Turn the locking lever (2) 90°.
10 Mbs/sec (10BASE-T, Ethernet) and 100 Mbs/sec
(100BASE-TX, Fast Ethernet), auto-recognition (10/100,
HalfDX/FullDX)
Network protocol: TCP
TCP/IP or UDP /IP
Compatible with the TCP standard, industry-compatible as
per CE, UL, cUL
Twisted pair, shielded, CAT-5 or higher, 1:1, UTP / STP,
male connector RJ45; e. g., patch cable CAT5 depending
on application (straight/crossover)
150 ohm
Max. 30 m
Interfaces
®
Cubis MSU User Manual 151