Sartorius Cubis MSU116P User Manual page 55

Leveler Configuration (Q-Level)
You can configure the leveling function here.
Leveling Notice
Off, no indication : Leveling prompt is disabled.
: As soon as leveling is required,
Display status
Level me! appears and flashes.
Alarm message, leveling required
Level me! appears and flashes. If this notice is ignored, an alarm message appears
after five minutes. If this occurs, you can only continue working after the balance
has been leveled.
Automatic Leveling (Balances with Motorized Leveling Feet Only)
Switch off, start with key
Switch on fully automatic
calibration/adjustment routine.
t
To save the settings, select
Power On Mode
t
Select the balance's startup mode for when the balance is switched on or when
the on/off key A is pressed repeatedly.
Options: On/standby or Always on
t
To save the settings, select
Power Saving Mode
t
Switch the power saving mode of the balance on or off.
: Power saving mode is not in use.
Off, no function
Automatic shutoff after 2 minutes
and control unit switches off if the device is idle for two minutes.
t
To save the settings, select
Restoring Factory Settings
You can reset all balance settings back to the default delivery status here
(after confirming the reset when prompted).
System Settings (Menu)
: As soon as leveling is required,
: Select to activate automatic leveling.
Start
: The balance is leveled automatically before every
Save .
Save .
: The backlight on the display
Save .
®
Cubis MSU User Manual 55