Setting Up The Lightwave Component Analyzer - Keysight N4376E Getting Started Manual

1 Getting Started

Setting Up the Lightwave Component Analyzer

CAUTION
CAUTION
CAUTION
CAUTION
24
The network analyzer and Lightwave Component Analyzer module are
assembled as one analyzer unit. Lifting this instrument requires two
people using proper lifting techniques. For the combined weight, please
consult the "User's Guide".
1 Unpack and inspect the contents as described in
Lightwave Component Analyzer
2 Remove the dust cap from the Optical Output.
If you are using a patchcord with a straight and angled connectors, make
sure you only connect the angled connector (green) to the optical test
set.
3 Remove the dust cap from the optical patchcord.
4 Connect the optical patchcord.
step 2 step 4
5 Repeat to
Always use patchcords to connect to your DUT. This protects the
connectors of the optical test set, by minimizing the number of connector
changes.
The contact connector on the optical test set is angled. If you are using a
patchcord with straight (red) and angled (green) connectors, make sure
you connect the angled connector to the optical test set.
Connecting to the optical test set with a straight connector will damage
it.
Keysight N4376E Lightwave Component Analyzer Getting Started Guide
on page 22".
for the optical input.
Unpacking the