N1911A/N1912A Option H01; Figure 2-66 Measurement Example For Option H01 - Keysight N1911A User Manual

General Power Meter Functions 2

N1911A/N1912A Option H01

N1911A/N1922A Option H01 replaces the recorder output on the rear panel with
NOTE
video output. The video output is the direct signal output detected by the sensor
diode, with no correction applied. The video output provides a DC voltage
proportional to the measured input power through a BNC connector on the rear
panel. The DC voltage can be displayed on an oscilloscope for time
measurement. The video output impedance is 50 Ω.
Figure 2-66 Measurement example for Option H01
Measurement example for Option H01
For this example, N1912A P-Series power sensors, MXG N5182A signal
generator, and Infiniium 54832D oscilloscope will be used.
1 Connect the power sensor input to the RF input of the signal generator.
2 Connect the video output of the power meter (Option H01) to the channel 1 of
the oscilloscope with a BNC cable.
3 Generate an RF Multitone waveform from the signal generator.
Keysight N1911A/1912A User's Guide 135