Figure 7-3 Reference Calibration Factor Pop-Up Window - Keysight N1911A User Manual

7 Using 8480 Series Power Sensors
Figure 7-3
5 Press
Now zero and calibrate the power meter/sensor combination as follows:
6 Press
7 Connect the power sensor to the POWER REF output.
8 Press
You can reduce the steps required to carry out the zero and calibration
NOTE
procedure as follows:
Now set the sensor calibration factor for the frequency of the signal you want to
measure.
9 Check the current reference calibration factor setting by pressing
214
Reference Calibration Factor pop-up window
to complete the entry.
%
and the channel
displayed.
and the channel
The Calibrating pop-up is then displayed.
1 Connect the power sensor to the POWER REF output.
2 Press and
,
Zero + Cal Zero + Cal A
. The value is displayed on the Cal Fac field.
Offset
softkey. The Zeroing pop-up is
Zero
softkey to start the calibration routine.
Cal
. (For dual channel meters, press
Zero + Cal
or
Zero + Cal B
Keysight N1911A/1912A User's Guide
as required).
,