Figure 2-45 Sensor Mode Pop-Up - Keysight N1911A User Manual

When E-Series E9320 or P-Series N1920 sensor is connected, the default sensor
NOTE
mode is Normal. User can use this Normal mode to perform power or frequency
sweep, or change the mode to AVG only to perform power or frequency sweep.
Refer
these two modes.
To change the sensor mode from the default Normal mode to AVG only mode,
follow the instructions below:
– Press
– Press
Figure 2-45
– Use the
4 Press
5 Press
6 Select either
Keysight N1911A/1912A User's Guide
Table 2-5 on the differences in measurement functions supported under
. Use the
to display the Sensor Mode pop-up.
Sensor Mode pop-up.
and
. The Trigger menu is displayed.
Acqn
softkey to configure the trigger.
Sing Trig
– is a single shot mode. After triggering, the measurement is
Sing Trig
halted, and the
by pressing the
– is a continuos trigger mode. The symbol
Cont Trig
and keys to highlight the Sensor Mode field.
keys to highlight the AVG and press
or .
Cont Trig
symbol is displayed. You can start another measurement
key.
General Power Meter Functions
or
2
.
is displayed.
107