Step 1. Connecting The Power Sensor; Step 2. Setting The Channel Frequency; Step 3. Setting The Trigger - Keysight N1911A User Manual

Step 1. Connecting the power sensor

When you initially connect an E-Series E9320 power sensor to the power meter,
the sensor's calibration data is automatically read by the power meter. After every
power cycle, the E9320 must perform zero and calibration as the P-Series power
meters do not retain the states and settings upon power cycle (warm start
feature).
Connect the sensor to the power source.

Step 2. Setting the channel frequency

– Press
– Use the
When you have completed the procedure you can return to this menu later to add
more accuracy to the measurement.

Step 3. Setting the trigger

To use the measurement gates the power meter must be triggered.
A trigger can be taken from a rising or falling measured power level or controlled
externally using the Ext Trig input.
Press
The trigger status is displayed below the
the
When you have completed the procedure you may return to the Trigger menu
later to add more accuracy to the remaining trigger parameters, to help you
achieve a stable and reliable trigger.
Keysight N1911A/1912A User's Guide
. The Channel Setup screen is displayed. If using an N1912A,
select the channel you want to configure.
, , , and
to configure the setting. See
page 60 for further information.
. The Trigger menu is displayed.
softkey and select
Acqn
Using E9320 E-Series Power Sensors
keys to highlight the frequency field. Press
"Setting the Measurement Frequency"
label in the Trigger menu. Press
Acqn
to configure continuous triggering.
Cont Trig
4
on
173