Step 1. Connecting the power sensor
When you initially connect a P-Series wideband power sensor to the power meter,
the sensor's calibration data is automatically read by the power meter. After the
sensor's data is read, the power meter automatically performs a zero and
calibration, see
further information.
Connect the sensor to the power source.
Step 2. Setting the channel frequency
Press
the channel you want to configure.
Use the
configure the setting. See
further information.
Figure 3-1
By default the sensor mode is set to Normal, users are allowed to change to AVG
NOTE
only mode whereby all the peak power measurement functions will be disabled.
Keysight N1911A/1912A User's Guide
"Zeroing and Calibrating the P-Series Sensor"
. The Channel Setup screen is displayed. If using an N1912A, select
,
,
, and
keys to highlight the frequency field. Press
"Setting the Measurement Frequency"
P-Series sensor default channel setup
Using P-Series Power Sensor
on page 140 for
on page 60 for
3
to
153