Figure 7-9 "Sensor Tbls" Screen - Keysight N1911A User Manual

7 Using 8480 Series Power Sensors
There are also ten sensor calibration tables named CUSTOM_0 through
CUSTOM_9. These tables do not contain any data when the power meter is
shipped from the factory.
Editing frequency dependent offset tables requires the following steps:
1 Identify and select the table you want to edit
2 Rename the table
3 Enter the frequency and offset pairs
4 Save the table
Procedure
First select the table you want to edit as follows:
1 Press
Figure 7-9
2 Choose the table you want to edit using the
222
, Tables
"Sensor Tbls" screen
to display the Ed it Cal screen as shown in
,
Sensor Cal Tables
Keysight N1911A/1912A User's Guide
to display the Sensor Tbls screen.
and keys. Press
Figure 7-10.
Ed it Table