Error Message List - Keysight N1911A User Manual

10 Maintenance

Error message list

Invalid character
An invalid character was found in the command string. You may have inserted a character such as #, $, or % in
–
101
the command header or within a parameter.
For example, LIM:LOW O#.
Syntax error
–
102
Invalid syntax was found in the command string.
For example, LIM:CLE:AUTO, 1 or LIM:CLE: AUTO 1.
Invalid separator
An invalid separator was found in the command string. You may have used a comma instead of a colon,
–
103
semicolon, or blank space; or you may have used a blank space instead of a comma.
For example, OUTP:ROSC,1.
GET not allowed
-105
A Group Execute Trigger (GET) is not allowed within a command string.
Parameter not allowed
More parameters were received than expected for the command. You may have entered an extra parameter,
–
108
or added a parameter to a command that does not accept a parameter.
For example, CAL 10.
Missing parameter
–
109
Fewer parameters were received than expected for the command. You omitted one or more parameters that
are required for this command. For example, AVER:COUN.
Program mnemonic too long
–
112
A command header was received which contained more than the maximum 12 characters allowed.
For example, SENSeAVERageCOUNt 8.
Undefined header
A command was received that is not valid for this power meter. You may have misspelled the command, it
–
113
may not be a valid command or you may have the wrong interface selected. If you are using the short form of
the command, remember that it may contain up to four letters.
For example, TRIG:SOUR IMM.
Invalid character in number
–
121
An invalid character was found in the number specified for a parameter value.
For example, SENS:AVER:COUN 128#H.
Exponent too large
–
123
A numeric parameter was found whose exponent was larger than 32,000.
For example, SENS:COUN 1E34000.
268 Keysight N1911A/1912A User's Guide