Zero/Cal Lockout
The Zero/Cal Lockout facility can help you make sure that a measurement cannot
be made until the power meter and sensor combination has been zeroed and
calibrated.
When the Zero/Cal Lockout facility is enabled and a sensor is initially connected,
the message Please Zero and Cal is displayed.
Figure 2-74
When you zero the sensor the message changes to
sensor before zeroing it, the message changes to
Dual channel meters display channel specific messages when a sensor is
connected. The Zero/Cal Lockout configuration is applied to both channels - it
cannot be applied to one channel only.
You can enable and disable the Zero/Cal Lockout facility from the System menu or
the Cal menu as follow:
Press
Similarly,
Keysight N1911A/1912A User's Guide
Please zero and calibrate window
,
,
1 of 2
Must Cal Off
General Power Meter Functions
Please Cal
Please Zero
or
.
On
. If you calibrate the
.
143
2