Quick Start For Step 7-Micro/Win 32; Pre-Installation Instructions; Installing Step 7-Micro/Win 32 - Siemens SIMATIC S7-200 System Manual

3.2

Quick Start for STEP 7-Micro/WIN 32

Pre-Installation Instructions

Before running the setup procedure, do the following:
If a previous version of STEP 7-Micro/WIN 32 is installed, back up all
STEP 7-Micro/WIN projects to diskette.
Make sure all applications are closed, including the Microsoft Office toolbar.
Be sure the cable between your personal computer and the CPU is connected.
See Section 3.3 for instructions.

Installing STEP 7-Micro/WIN 32

Use the following procedure to install the STEP 7-Micro/WIN 32 software:
1. Start by inserting the CD or disk in the CD or disk drive of your computer.
2. Click once on the "Start" button to open the Windows menu.
3. Click on the Run... menu item.
4. If you are installing from a diskette: In the "Run" dialog box, type a:\setup
and click on OK or press
If you are installing from a CD: In the "Run" dialog box, type e:\setup
(where "e" is the drive letter of the CD) and click on OK or press
starts the setup procedure.
5. Follow the online setup procedure to complete the installation.
6. The installation will automatically display the "Set the PG/PC Interface" dialog
box. The PG/PC interface parameter is set up later in this chapter. Click on
Cancel to continue.
7. The "Setup Complete" dialog box is now displayed with one of the following
options:
Option 1: Yes, I want to restart my computer now. (default selected)
If Option 1 is displayed, it is recommended that you accept the default
settings, and select Finish to complete the installation and view the Read
Me file for the the most recent information about STEP 7-Micro/WIN 32.
Option 2: Yes, I want to view the Read Me file now. (default selected)
If Option 2 is displayed, it is recommended that you accept the default
settings and select Finish to complete the installation and view the Read
Me file for the most recent information about STEP 7-Micro/WIN 32.
For Option 2: both options can be selected. Selecting Finish with both
options selected will complete the installation, display the Read Me file and
launch STEP 7-Micro/WIN 32. See Figure 3-1.
S7-200 Programmable Controller System Manual
A5E00066097-02
Getting Started with an S7-200 Programming System
. This starts the setup procedure.
ENTER
No, I will restart my computer later
No, I want to launch STEP 7-Micro/WIN 32 now.
. This
ENTER
3-3