ABB IRB 140 Product Manual page 129

Irb 140 series type c
Hide thumbs Also See for IRB 140:
Table of Contents

Advertisement

3
Refitting the damper axis 3
Use this procedure to refit the damper.
1
2
3
4
3HAC027400-001 Revision: K
Action
Remove the damper by gently prying it from
the cast tab.
Action
Run the robot to a position where it is best
to enable access to the location where the
axis 3 damper is fitted.
DANGER
Turn off all:
electric power supply
hydraulic pressure supply
air pressure supply
to the robot, before entering the robot work-
ing area.
Refit the damper by gently pressing it onto
the cast tab on the upper arm.
DANGER
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in the section
test run may cause injury or damage! on
page
44.
© Copyright 2004-2013 ABB. All rights reserved.
4.4.2 Replacing the damper, axis 3
Note
Note
Shown in the figure
axis 3 on page
DANGER - First
4 Repair
Continued
Location of damper,
128.
129

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Irb 140-6/0.8Irb 140tIrb 140t-6/0.8

Table of Contents